Difference between revisions of "FT245RL V1.5"
Jump to navigation
Jump to search
| Line 3: | Line 3: | ||
This is the documentation page for the FT245RL breakout board. That can be bought in the [http://www.bitwizard.nl/shop/breakout-boards/ft245rl-breakout-board BitWizard shop]. |
This is the documentation page for the FT245RL breakout board. That can be bought in the [http://www.bitwizard.nl/shop/breakout-boards/ft245rl-breakout-board BitWizard shop]. |
||
== |
== Overview == |
||
The FT245RL breakout board has an USB connector, one 16-pin IO connector. The brains of the PCB, of course, is an FT245RL chip. |
The FT245RL breakout board has an USB connector, one 16-pin IO connector. The brains of the PCB, of course, is an FT245RL chip. |
||
| Line 12: | Line 12: | ||
* [http://www.ftdichip.com/Products/ICs/FT245R.htm FTDI product page] |
* [http://www.ftdichip.com/Products/ICs/FT245R.htm FTDI product page] |
||
== |
== Pinout == |
||
The 16-pin connector is connected as follows: |
The 16-pin connector is connected as follows: |
||
Revision as of 16:50, 6 November 2015
This is the documentation page for the FT245RL breakout board. That can be bought in the BitWizard shop.
Overview
The FT245RL breakout board has an USB connector, one 16-pin IO connector. The brains of the PCB, of course, is an FT245RL chip.
External resources
Pinout
The 16-pin connector is connected as follows:
| 5V | 3V3 |
| TXE# | RXF# |
| RD# | WR |
| D7 | D5 |
| D5 | D4 |
| D3 | D2 |
| D1 | D0 |
| GND | GND |
LEDS
- The only LED is a power LED
Jumper settings
The only jumper is for selecting the I/O voltage. Place the jumper on the left side for 3V3, or on the right side for 5V.
future hardware enhancements
Changelog
1.1
- Initial public release