From BitWizard WIKI
Revision as of 18:31, 16 September 2014 by Tom
This is the documentation page for the FT311D breakout board.
The FT311D breakout board has an USB connector, one 12-pin IO connector. The brains of the PCB, of course, is an FT311D chip.
The 12-pin connector is connected as follows:
- The only LED is a power LED
- The jumpers are, from left to right, for CNFG2, CNFG1, and CNFG0. Placing a jumper connects the config pin to GND, removing it leaves the pin open. Please see the datasheet for the correct jumper settings.
future hardware enhancements
- Initial public release