Difference between revisions of "FTDI serial"
From BitWizard WIKI
(Created page with '= FTDI-serial board = This is the documentation page for the FTDI-serial board. == overview == The FTDI-serial board has an USB connector and a 3-pin serial/UART connector. T…') |
|||
Line 28: | Line 28: | ||
== future hardware enhancements == | == future hardware enhancements == | ||
+ | |||
+ | |||
+ | |||
+ | == Changelog == | ||
+ | |||
+ | 1.0 | ||
+ | * Initial public release |
Revision as of 15:30, 16 November 2011
Contents
FTDI-serial board
This is the documentation page for the FTDI-serial board.
overview
The FTDI-serial board has an USB connector and a 3-pin serial/UART connector. The brains of the PCB is an FT232RL chip.
pinout
The 3 pin connector is connected as follows
1 | Ground (G) |
2 | Rx (R) |
3 | Tx (T) |
- led1 is connected to CBUS0 (Tx activity)
- led2 is connected to BCUS1 (Rx activity)
- led3 is connected to VCC
Jumper settings
IO voltage
1-2: 3V3 (jumper near C2)
2-3: 5V (jumper near the edge of the board
future hardware enhancements
Changelog
1.0
- Initial public release