Difference between revisions of "FTDI serial 2"

From BitWizard WIKI
Jump to: navigation, search
(Created page with "This is the documentation page for the FTDI-serial 2 board. == overview == The FTDI-serial 2 board has an USB connector and a 4-pin serial/UART connector. The brains of the...")
 
m (pinout)
Line 15: Line 15:
 
<tr><td>2</td><td>Rx (R)</td></tr>
 
<tr><td>2</td><td>Rx (R)</td></tr>
 
<tr><td>3</td><td>Tx (T)</td></tr>
 
<tr><td>3</td><td>Tx (T)</td></tr>
<tr><td>3</td><td>VCC (T)</td></tr>
+
<tr><td>4</td><td>VCC (T)</td></tr>
 
</table>
 
</table>
  

Revision as of 17:12, 18 April 2012

This is the documentation page for the FTDI-serial 2 board.

overview

The FTDI-serial 2 board has an USB connector and a 4-pin serial/UART connector. The brains of the PCB is an FT232RL chip.

External resources

pinout

The 4 pin connector is connected as follows

1Ground (G)
2Rx (R)
3Tx (T)
4VCC (T)
  • led1 is connected to CBUS0 (Tx activity)
  • led2 is connected to BCUS1 (Rx activity)
  • led3 is connected to VCC

Jumper settings

IO voltage
1-2: 3V3 (place jumper near FTDI)
2-3: 5V (place jumper near UART header)

future hardware enhancements

Changelog

2.0

  • Size reduced considerably
  • Added an VCC pin to the Rx/Tx connector

1.0

  • Initial public release