FTDI serial 2
This is the documentation page for the FTDI-serial 2 board. That you can buy in the BitWizard shop.
The FTDI-serial 2 board has an USB connector and a 4-pin serial/UART connector. The brains of the PCB is an FT232RL chip.
The 4 pin connector is connected as follows
- led1 is connected to CBUS0 (Tx activity)
- led2 is connected to BCUS1 (Rx activity)
- led3 is connected to VCC
1-2: 3V3 (place jumper near FTDI)
2-3: 5V (place jumper near UART header)
future hardware enhancements
- Size reduced considerably
- Added an VCC pin to the Rx/Tx connector
- Initial public release