Difference between revisions of "FT312D"
Jump to navigation
Jump to search
(Created page with "This is the documentation page for the FT312D breakout board. == overview == The FT312D breakout board has an USB connector, one 12-pin IO connector. The brains of the PCB,...") |
|||
| Line 1: | Line 1: | ||
[[File:FT312D.jpg|thumb|300px]] |
|||
This is the documentation page for the FT312D breakout board. |
This is the documentation page for the FT312D breakout board. |
||
Revision as of 17:31, 16 September 2014
This is the documentation page for the FT312D breakout board.
overview
The FT312D breakout board has an USB connector, one 12-pin IO connector. The brains of the PCB, of course, is an FT312D chip.
External resources
pinout
The 12-pin connector is connected as follows:
| 5V | 3V3 |
| USB ERROR#(jumpered) | TEST0 |
| NC | NC |
| TX_ACTIVE | CTS# |
| RTS# | RXD |
| TXD | GND |
LEDS
- The only LED is a power LED
Jumper settings
- The left two jumpers should be placed, the third (right) jumper should NOT be placed.
future hardware enhancements
Changelog
1.1
- Initial public release