Dio breakout
This is the documentation page for the DIO_breakout .
Overview
This board enables use screw terminals to connect wires to your SPI_DIO or I2C_DIO board.
Assembly instructions
None: the board comes fully assembled.
External resources
Additional software
Related projects
Pinout
The connector at the bottom of the board is laid out as follows:
| pin | function |
|---|---|
| 1 | GND |
| 2 | IO0 |
| 3 | IO1 |
| 4 | IO2 |
| 5 | IO3 |
| 6 | IO4 |
| 7 | IO5 |
| 8 | IO6 |
the power-connector at the top of the board is laid out as follows:
| pin | function |
|---|---|
| 1 | GND |
| 2 | VCC |
| 3 | GND |
| 4 | VCC |
| 5 | GND |
| 6 | VCC |
| 7 | GND |
| 8 | VCC |
The dataconnector in the middle of the board is compatible with the DIO board:
| pin | function |
|---|---|
| 1 | GND |
| 2 | VCC |
| 3 | IO0 |
| 4 | IO1 |
| 5 | IO2 |
| 6 | IO3 |
| 7 | d.n.c. |
| 8 | IO4 |
| 9 | IO5 |
| 10 | IO6 |
jumper settings
There are no jumpers.
Future hardware enhancements
Future software enhancements
Changelog
1.0
- Initial public release