Difference between revisions of "7FETs"

From BitWizard WIKI
Jump to: navigation, search
(Future software enhancements)
m (moved SPI 6FETs to SPI 7FETs)
(No difference)

Revision as of 15:32, 15 February 2012


This is the documentation page for the SPI_6FETs board.


The board has 7 fets that allow you to pull a pin of a load low. You would normally tie the other end of your load directly to the powersupply.

About 1A per output should be possible. Maximum voltage is 20V.

You will have to provide your own protection circuits if you are going to drive inductive loads (like a motor).

Assembly instructions

Possible Configurations

External resources


Additional software

Related projects



Power connector

The connector SV2 allows you to connect the "powersource".

You can chose two configurations: You can use pin 1-2 as ground and power. You can connect up to 15V (*) to pin 2 referenced to GND on pin 1.

(*) The datasheet for the used transistors mentions "20V", but is is always prudent to keep some margin.

If you want 5V as the powersource, you could put a jumper on pin 2-3. In that case you will have to be aware that you're using the 5V power from the rest of the system. This will be limited by e.g. USB power limits, other devices on the SPI bus, cable thickness and connector capability. But for low-current 5V applications this might be useful.

jumper settings

See solder jumpers on how to change the solder jumper.

By changing the solder jumper SJ1, you can make the connector nearest the board edge into the ICSP programming connector for the attiny44 on the board.


The software

Default operation

Future hardware enhancements

Future software enhancements

TODO: write a library to make handling this board easy.



  • Initial public release