This is the documentation page for the DIO_breakout .
This board enables use screw terminals to connect wires to your SPI_DIO or I2C_DIO board.
None: the board comes fully assembled.
The connector at the bottom of the board is laid out as follows:
the power-connector at the top of the board is laid out as follows:
The dataconnector in the middle of the board is compatible with the DIO board:
There are no jumpers.
You can chose to have your board equipped with a 10-pin female connector that allows your board to directly fit on top of the I2C-DIO board. This would conflict with the SPI connectors so don't chose this option for an SPI_DIO.
You can chose to have your board equipped with a male 10-pin connector that allows you to connect your board with the SPI_DIO or I2C DIO using a short 10pin IDC cable.
Future hardware enhancements
Future software enhancements
- Initial public release