This is the documentation page for the FT311D breakout board. The can be bought in the BitWizard shop.
The FT311D breakout board has an USB connector, one 12-pin IO connector. The brains of the PCB, of course, is an FT311D chip.
using the board
The board can not be powered from your mobile phone, you will need to supply 5V on the 5V header pin. This will also charge your phone.
This board is compatible with AOA (Android Open Accessory), and for example the PodMode app.
The 12-pin connector is connected as follows:
- The only LED is a power LED
- The jumpers are, from left to right, for CNFG2, CNFG1, and CNFG0. Placing a jumper connects the config pin to GND, removing it leaves the pin open. Please see the datasheet for the correct jumper settings.
future hardware enhancements
- jumper to be able to disconnect the 5V header pin from the 5V USB pin
- Initial public release