Difference between revisions of "FT311D"

From BitWizard WIKI
Jump to: navigation, search
(Created page with "This is the documentation page for the FT311D breakout board. == overview == The FT311D breakout board has an USB connector, one 12-pin IO connector. The brains of the PCB,...")
(No difference)

Revision as of 16:45, 16 September 2014

This is the documentation page for the FT311D breakout board.

overview

The FT311D breakout board has an USB connector, one 12-pin IO connector. The brains of the PCB, of course, is an FT311D chip.

External resources

pinout

The 12-pin connector is connected as follows:

5V3V3
USB ERROR#(jumpered)TEST0
IOBUS6IOBUS5
IOBUS4IOBUS3
IOBUS2IOBUS1
IOBUS0GND

LEDS

  • The only LED is a power LED

Jumper settings

  • The jumpers are, from left to right, for CNFG2, CNFG1, and CNFG0. Placing a jumper connects the config pin to GND, removing it leaves the pin open. Please see the datasheet for the correct jumper settings.

future hardware enhancements

Changelog

1.1

  • Initial public release