Difference between revisions of "FTDI serial"
From BitWizard WIKI
(→overview) |
|||
| Line 6: | Line 6: | ||
The FTDI-serial board has an USB connector and a 3-pin serial/UART connector. The brains of the PCB is an FT232RL chip. | The FTDI-serial board has an USB connector and a 3-pin serial/UART connector. The brains of the PCB is an FT232RL chip. | ||
| + | |||
| + | == External resources == | ||
== pinout == | == pinout == | ||
Revision as of 16:04, 25 November 2011
Contents
FTDI-serial board
This is the documentation page for the FTDI-serial board.
overview
The FTDI-serial board has an USB connector and a 3-pin serial/UART connector. The brains of the PCB is an FT232RL chip.
External resources
pinout
The 3 pin connector is connected as follows
| 1 | Ground (G) |
| 2 | Rx (R) |
| 3 | Tx (T) |
- led1 is connected to CBUS0 (Tx activity)
- led2 is connected to BCUS1 (Rx activity)
- led3 is connected to VCC
Jumper settings
IO voltage
1-2: 3V3 (jumper near C2)
2-3: 5V (jumper near the edge of the board
future hardware enhancements
Changelog
1.0
- Initial public release
