Difference between revisions of "I2C connector pinout"
From BitWizard WIKI
(Created page with " For the interconnect between I2C masters and the I2C expansion boards BitWizard uses a 4-pin I2C cable. {| border=1 ! pin !! function !! remark |- | 1 || GND || Power Grou...") |
(No difference)
|
Revision as of 15:56, 6 April 2012
For the interconnect between I2C masters and the I2C expansion boards BitWizard uses a 4-pin I2C cable.
| pin | function | remark |
|---|---|---|
| 1 | GND | Power Ground |
| 2 | SDA | Serial I2C Data |
| 3 | SCK | Serial I2C Clock |
| 4 | VCC | Power 5V. |
The connector is laid out as follows:
Connecting the bitwizard boards to an Arduino
| pin | function | arduino pin |
|---|---|---|
| 1 | GND | GND |
| 2 | SDA | A4 (Analog input 4) |
| 3 | SCK | A5 (analog input 5) |
| 4 | VCC | VCC |
You could use other pins, but then you have to make a software I2C implementation. This is not too difficult, but might be neccesary if something else is already on the I2C pins.
