Difference between revisions of "Rtc"

From BitWizard WIKI
Jump to: navigation, search
Line 1: Line 1:
First, the i2c-bcm2708 i2c driver needs to be loaded. As far as I know, in the first few months of the raspberry pi being available, the module was blacklisted and didn't load automatically, but nowadays the module is loaded by default. If it isn't on your system:  
+
First, the i2c-bcm2708 i2c driver needs to be loaded. As far as I know, in the first few months of the raspberry pi being available, the module was blacklisted and didn't load automatically. Nowadays "raspi-config" will already give you the option to enable the driver.
 +
 
 +
What "raspi-config" does (but you can also do by hand) is remove the drivers from /etc/modprobe.d/raspi-blacklist.conf .  
 +
 
 +
If the driver isn't loaded on your system start with:  
 
  sudo modprobe i2c-bcm2708
 
  sudo modprobe i2c-bcm2708
  
Load the I2C and RTC drivers as root:
+
Then load the I2C and RTC drivers as root:
 
  sudo -s
 
  sudo -s
 
  modprobe i2c-dev
 
  modprobe i2c-dev

Revision as of 10:31, 11 January 2015

First, the i2c-bcm2708 i2c driver needs to be loaded. As far as I know, in the first few months of the raspberry pi being available, the module was blacklisted and didn't load automatically. Nowadays "raspi-config" will already give you the option to enable the driver.

What "raspi-config" does (but you can also do by hand) is remove the drivers from /etc/modprobe.d/raspi-blacklist.conf .

If the driver isn't loaded on your system start with:

sudo modprobe i2c-bcm2708

Then load the I2C and RTC drivers as root:

sudo -s
modprobe i2c-dev
modprobe i2c:mcp7941x
echo mcp7941x 0x6f > /sys/class/i2c-dev/i2c-0/device/new_device  # For rev1 RPi
echo mcp7941x 0x6f > /sys/class/i2c-dev/i2c-1/device/new_device  # For rev2 RPi

To write the system time to the RTC (you might need to run this command twice, when you use the RTC for the first time):

hwclock -w

Read out the RTC, and print the date and time to your console:

hwclock

Read out the RTC, and adjust system time:

hwclock -s

To automatically do this on startup, add the following lines to /etc/rc.d/rc.local

modprobe i2c-dev
modprobe i2c:mcp7941x
echo mcp7941x 0x6f > /sys/class/i2c-dev/i2c-0/device/new_device  # For rev1 RPi
echo mcp7941x 0x6f > /sys/class/i2c-dev/i2c-1/device/new_device  # For rev2 RPi
hwclock -s

Source: http://www.element14.com/community/message/63885