Difference between revisions of "Dio breakout"
From BitWizard WIKI
(Created page with "The DIO breakout board. This is the documentation page for the DIO_breakout . == Overview == This board en...") |
(→Pinout) |
||
Line 27: | Line 27: | ||
+ | The connector at the bottom of the board is laid out as follows: | ||
{| border=1 | {| border=1 | ||
! pin !! function | ! pin !! function | ||
Line 47: | Line 48: | ||
|} | |} | ||
+ | |||
+ | the power-connector at the top of the board is laid out as follows: | ||
{| border=1 | {| border=1 | ||
Line 68: | Line 71: | ||
|} | |} | ||
− | + | The dataconnector in the middle of the board is compatible with the DIO board: | |
+ | {| border=1 | ||
+ | ! pin !! function | ||
+ | |- | ||
+ | | 1 || GND | ||
+ | |- | ||
+ | | 2 || VCC | ||
+ | |- | ||
+ | | 3 || IO0 | ||
+ | |- | ||
+ | | 4 || IO1 | ||
+ | |- | ||
+ | | 5 || IO2 | ||
+ | |- | ||
+ | | 6 || IO3 | ||
+ | |- | ||
+ | | 7 || d.n.c. | ||
+ | |- | ||
+ | | 8 || IO4 | ||
+ | |- | ||
+ | | 9 || IO5 | ||
+ | |- | ||
+ | | 10 || IO6 | ||
+ | |} | ||
== jumper settings == | == jumper settings == |
Revision as of 15:19, 17 May 2013
This is the documentation page for the DIO_breakout .
Contents
Overview
This board enables use screw terminals to connect wires to your SPI_DIO or I2C_DIO board.
Assembly instructions
None: the board comes fully assembled.
External resources
Datasheets
Additional software
Related projects
Pinout
The connector at the bottom of the board is laid out as follows:
pin | function |
---|---|
1 | GND |
2 | IO0 |
3 | IO1 |
4 | IO2 |
5 | IO3 |
6 | IO4 |
7 | IO5 |
8 | IO6 |
the power-connector at the top of the board is laid out as follows:
pin | function |
---|---|
1 | GND |
2 | VCC |
3 | GND |
4 | VCC |
5 | GND |
6 | VCC |
7 | GND |
8 | VCC |
The dataconnector in the middle of the board is compatible with the DIO board:
pin | function |
---|---|
1 | GND |
2 | VCC |
3 | IO0 |
4 | IO1 |
5 | IO2 |
6 | IO3 |
7 | d.n.c. |
8 | IO4 |
9 | IO5 |
10 | IO6 |
jumper settings
There are no jumpers.
Future hardware enhancements
Future software enhancements
Changelog
1.0
- Initial public release